Bushing Lock is a three component, 100% solids, VOC-free, epoxy resin system designed for high temperature, heat-absorbing applications. It is specifically intended for use in eccentric assemblies on cone crushers to "lock" the inner and outer eccentric bushings and prevent the bushing from turning.

PACKAGING/CONVENIENCE

Bushing Lock's three components are conveniently packaged in a 2 gallon pail for shipping, storage and mixing. All amounts are pre-measured. Do not mix less than full kits. (Attempts to "eye-ball" ratios of partial kits will produce uncertain results.) To use, pour the resin, hardener and filler into the 2 gallon pail and mix with a slow speed drill until a uniform color appears, usually 3 to 4 minutes.

WORKLIFE

The worklife (the time you have before it sets) of Bushing Lock will vary according to the air temperature. The average worklife at 72 ° F will be 10-15 minutes. In cooler weather you will have more time to pour the material and in hotter weather you will have less time.

PHYSICAL PROPERTIES

VOLUME PER KIT: 110 CUBIC INCHES

APPLICATION TEMPERATURE: 55 – 95 ° F

CLEANLINESS AND SAFETY

Avoid skin contact with resin and hardener. Wash with soap and water after using. Use in a well-ventilated area and avoid prolonged breathing of vapors or filler dust.

Material Safety Data Sheets are available upon request. Read and understand material safety data sheets before using material.

Do not weld on or near the hardened bushing lock; hazardous fumes will be released.

WARRANTY AND DISCLAIMER

Copps Industries, Inc. gives no warranty, express or implied, and all products are sold upon conditions that purchasers will make their own tests to determine the quality and suitability of the product. Copps Industries, Inc. shall be in no way responsible for the proper use and service of the product. The information given in this publication is considered to be accurate and reliable and is provided as a service only. Physical properties shown are typical. Actual properties are dependent on curing conditions and degree of cure. Any information or suggestions given are without warranty of any kind and purchasers are solely responsible for any loss arising from the use of such information or suggestions. No information or suggestions given by us shall be deemed to be a recommendation to use any product in conflict with any existing patent rights.