Copps K-024 Cold Cure backing is a 100% solids, solvent free, 2-part epoxy system designed to be poured when air temperatures are between 25 ° F and 60 ° F. Optimum pouring temperature range is 45-55 ° F, which allows for typical worklife and installation. K-024 MUST BE STORED AT, OR WARMED TO, 45-65 ° F. Do not use K-024 at temperatures ABOVE 65 ° F; the worklife is too short and cracking may result.

PHYSICAL PROPERTIES

REMEMBER

1. Store at 45-65 ° F
2. Warm to 45-65° F prior to use.
3. DO NOT use above 65°F!
4. Add hardener to resin, mix to uniform color, pour immediately.
5. USE ENTIRE KIT - DO NOT PORTION!

HANDLING PROCEDURE

Copps Cold Cure backing must be stored between 45 ° F and 65 ° F prior to use. To use, pour the hardener into the resin and mix until a uniform color appears, usually 2-3 minutes. Pour this material immediately after mixing; working time is much shorter than the standard backing.

SAFETY PRECAUTIONS

Avoid breathing of vapors. Forced local exhaust is recommended to effectively minimize exposure. NIOSH approved, organic vapor respirators and forced exhaust are recommended in confined areas, or when conditions (such as heated polymers, sanding) may cause high vapor concentrations. Do not weld on or burn the backing. Hazardous vapor is released when the backing is burned.

Avoid skin or eye contact with hardener. Wash skin with soap and water if contact occurs. If eye contact occurs flush with water for 15 minutes and obtain medical attention.

Read and understand all cautions on can labels and material safety data sheets before using this material.

WARRANTY AND DISCLAIMER

Copps Industries, Inc. gives no warranty, express or implied, and all products are sold upon condition that purchasers will make their own tests to determine the quality and suitability of the product. Copps Industries, Inc. shall be in no way responsible for the proper use and service of the product. The information given in this publication is considered to be accurate and reliable and is provided as a service only. Physical properties shown are typical. Actual properties are dependent on curing conditions and degree of cure. Any information or suggestions given are without warranty of any kind and purchasers are solely responsible for any loss arising from the use of such information or suggestions. No information or suggestions given by us shall be deemed to be a recommendation to use any product in conflict with any existing patent rights.