Bushing Lock DOT Non-Hazardous (K-113)

EPOXY COMPOUND FOR LOCKING ECCENTRIC BUSHINGS ON CONE CRUSHERS

K-113 BUSHING LOCK is a three-component, 100% solids, VOC, BGE1 and nonyl phenol2 free, epoxy resin system designed for high temperature, heat-absorbing applications. It is specifically intended for use in eccentric assemblies on cone crushers to “lock” the inner and outer eccentric bushings and prevent the bushing from turning. K-113 is a DOT non-corrosive, user friendly and safer alternative of standard K-007 bushing compound.

PHYSICAL PROPERTIES
MIXED VISCOSITY, cP or mPa.s 6,500   ASTM D 2196
COMPRESSIVE STRENGTH, psi (MPa) 13,800 (95) ASTM D 695
HARDNESS, Shore D 87   ASTM D 2240
MAX. CONTINUOUS SERVICE TEMPERATURE, °F (°C) 250 (121)  
SPECIFIC GRAVITY, g/cm3 1.5   ASTM D 792
GEL TIME @ 72 °F (22 °C), min 28   ASTM D 2471

WORKING/MIXING/TEMPERATURE CONSIDERATIONS

The working time (the time you have before it sets) of BUSHING LOCK will vary according to the air temperature. The average working time at 72 °F (22 °C) will be 10-15 minutes. In cooler weather you will have more time to pour the material and in hotter weather you will have less time. All three components in each kit are pre-measured. Do not mix less than full kits. (Attempts to “eye-ball” ratios of partial kits will produce uncertain results.) To use, pour the resin, hardener and filler into the 2-gallon pail and mix with a slow speed drill until a uniform color appears, usually 3 to 4 minutes.

APPLICATION TEMPERATURE

55-95 °F (13-35 °C)

VOLUME PER KIT

110 in.3 (1,800 cm3)

SAFETY PRECAUTIONS

Avoid breathing of vapors. Forced local exhaust is recommended to effectively minimize exposure. NIOSH approved, organic vapor respirators and forced exhaust are recommended in confined areas, or when conditions (such as heated polymers, sanding) may cause high vapor concentrations. DO NOT WELD ON, BURN OR TORCH ON OR NEAR, ANY EPOXY MATERIAL. HAZARDOUS VAPOR IS RELEASED WHEN AN EPOXY IS BURNED. Read and understand all cautions on can labels and material safety data sheets before using this material.

WARRANTY AND DISCLAIMER

Copps Industries, Inc. gives no warranty, express or implied, and all products are sold upon conditions that purchasers will make their own tests to determine the quality and suitability of the product. Copps Industries, Inc. shall be in no way responsible for the proper use and service of the product. The information given in this publication is considered to be accurate and reliable and is provided as a service only. Physical properties shown are typical. Actual properties are dependent on curing conditions and degree of cure. Any information or suggestions given are without warranty of any kind and purchasers are solely responsible for any loss arising from the use of such information or suggestions. No information or suggestions given by us shall be deemed to be a recommendation to use any product in conflict with any existing patent rights.

  1. Butyl Glycidyl Ether. The EPA (SARA Title III, section 312) lists BGE as “Toxic” (per ANSI Z129.1) by skin absorption and an immediate health hazard.
  2. Nonyl Phenol is a Marine Pollutant and considered “Dangerous for the environment” per the EU directive 79/831/EEC.

TB#4113 (09/08/09)